Officeserv - Samsung Officeserv 7100 Technical Manual

OfficeServ 7100

TECHNICAL MANUAL
Software Setup
The following MMC's must be programmed for each node in the network:
1. The following MMC's related to IP and MGI set up must be programmed MMC 830.
System IP Address for MP10/MP10a.
Configure the MP10/MP10a with the relevant IP information:
• Assign IP Address, Default Gateway, and Subnet Mask, then restart the system
for the changes to take effect.
• Select IP type (private, public, or private with public) and assign public IP if
applicable.
MMC 831. MGI PARAMETERS
Note: If you are using the on-board MGI channels, this is a "Read-Only" MMC. The
settings here will be the same as MMC 830.
Configure the MGI card with the relevant IP information:
• Assign IP Address, Default Gateway, Subnet Mask for each MGI card, then
restart the MGI card/s for the changes to take effect. Card can be reset using the
reset option in MMC 831.
• Select IP type (private, public, or private with public) and assign public IP if
applicable.
MMC 835. MGI DSP Options
Configure the MGI card with the relevant IP information:
• AUDIO CODEC must be set for G.729A in each node for IP networking
MMC 615. MGI Use Group
Add the IP trunk members (MGI Channels) for the VoIP Networking function.
1. USER field should be set to "VoIP Networking". Select the IP trunk members for
this function. Each IP trunk represents an MGI channel.
MMC 616. MGI Fixed User
If needed you can use this MMC to permanently dedicate MGI channels for a
specific function. These settings will over-ride the functional assignments in MMC
615. For example, you can assign channels 3801 and 3802 to always be used only
for the "VoIP Networking" function.
2.8.2
Table of Contents
Home Page
SPECIAL APPLICATIONS
PART 2 JANUARY 2009