Samsung Officeserv 7100 Technical Manual page 5

OfficeServ 7100
TECHNICAL MANUAL
MMC 501 SYSTEM TIMERS
MMC 415 TRK. ABANDON
MMC 608 ASSIGN REV BLOCK
MMC 701 ASSIGN COS
MMC 724 NUMBER PLAN
In addition to the above MMCs, it is necessary to have LCR programmed on the system
to enable certain features with a DIAL/REDIAL option to be used. This is because the
number format provided by the Central Office contains the area code. This area code
must be stripped off in the LCR modified digits section to allow a local number to be
correctly dialed.
For example, if the system is located in the 305 area code, the LCR digit table points
the entry 1305 to a modified digits entry that deletes the first four digits of the CID
number. Of course, this is a much simplified LCR scheme. As there are long distance
calls to be made within the home area code, additional entries are required to identify
these.
For example, if 1305-426 is a local call, the area code has to be stripped, but if 1305-
858 is long distance, the area code has to remain to allow the number to be dialed.
There are two ways of doing this. You can either enter all of the local office codes and
tell the system to strip the area code from them or you can enter the long distance
codes and tell them to ignore the modify digits entry.
A list of all of the local office codes can be found at the front of the local telephone
directory.
determine which piece of Caller ID data is
displayed when a call rings at the user's station.
This MMC is primarily used when displaying
transferred calls.
This MMC has two new timers related to Caller ID.
The only timer that may need adjustment is the
CID DISPLAY TIME. This is the length of time that
CID data is displayed after the CID key is pressed.
This MMC is used by the technician to determine
which trunks will record data in the Call Abandon
list and print with an Abandon "A" flag on SMDR.
This MMC is used by the technician to assign CID
Review blocks to keysets to allow the user to
review CID data for previous calls.
All of the Caller ID features have been added to
this MMC to enable the technician to allow or
deny them.
The Caller ID features have been added to this
MMC to allow a technician to assign an access
code where necessary.
2.2.2
Table of Contents
Home Page
SPECIAL APPLICATIONS
PART 2 APRIL 2007