Connecting To Network And Devices; Ethernet; Wi-Fi - Grandstream Networks GVC3200 User Manual

CONNECTING TO NETWORK AND DEVICES

The GVC3200 supports a variety of network connections (Ethernet, Wi-Fi) and device connections,
including USB, SD card and Bluetooth device. For first-time users, please connect to USB mouse for
configuration on device, or log in the GVC3200 web UI to use the virtual remote configuration. For more
information about using
www.grandstream.com

ETHERNET

If you would like to use Ethernet connection for network access, you can plug the Ethernet cable to the
LAN port on the back of the GVC3200. Ethernet connection is turned on as DHCP by default.
To configure Ethernet settings on GVC3200:
1. Plug the Ethernet cable into the LAN port on the back of the GVC3200.
2. Go to LCD menu->Settings->Network->Ethernet->IPv4 Settings.
3. Tap on "Address Type" to select DHCP, Static IP or PPPoE as the address type.
 For DHCP, save the setting and the GVC3200 should be able to get IP address from the DHCP
server in the network.
 For static IP, enter IP Address, Subnet Mask, Default Gateway, DNS Server and Alternative DNS
server for the GVC3200 to correctly connect to the network.
 For PPPoE, enter PPPoE account ID and password so the GVC3200 can get IP address from the
PPPoE server.

WI-FI

Wi-Fi is supported and built-in on the GVC3200. On the LCD display, go to Settings->Network-> Wi-Fi.
Firmware Version 1.0.0.X
web UI, please
.
GVC3200 User Guide
refer to the GVC3200 Administration Guide in
Page 27 of 86