Programming Signals From Other Remote Controls - Pioneer VSX-1015TX Operating Instructions Manual

Controlling the rest of your system
Programming signals from other
remote controls
If the preset code for your component is not available, or
the available preset codes do not operate correctly, you
can program signals from the remote control of another
component. This can also be used to program additional
operations (buttons not covered in the presets) after
assigning a preset code.
1 While pressing the RECEIVER button, press and
hold the 1 button.
The remote LCD display shows SETUP.
2 Press the MULTI CONTROL button for the
component you want to control.
The LCD on the remote displays the component you want
to control.
• You can't assign the RECEIVER button.
3 Use (cursor left/right) to select LEARN then
press ENTER.
PRES KEY shows in the LCD display.
• To exit or cancel press RECEIVER.
4 Point the two remote controls towards each
other then press the button that will be doing the
learning on this receiver's remote control.
PRES KEY starts flashing to indicate the remote is ready
to accept a signal.
• The remote controls should be 1–2 inches apart.
1 – 2 inches
5 Press the corresponding button on the other
remote control that is sending (teaching) the signal
to this receiver's remote control.
For example, if you want to learn the playback control
signal, press and hold for a couple of seconds. The
LCD display will show OK if the operation has been
learned.
If for some reasons the operation hasn't been learned the
LCD will display ERROR briefly and then display PRES
KEY again. If this happens, keep pressing the (teaching)
button as you vary the distance between the two remotes,
until the LCD display shows OK.
Certain buttons represent operations that cannot be
learned from other remote controls. The buttons
available are shown below:
INPUT
RECEIVER
SELECT
DVD/LD TV/SAT
MULTI CONTROL
CD CD-R/TAPE
INPUT ATT
+10
D.ACCESS
TOP MENU
TUNE
ST
DTV MENU
T.EDIT
TUNE
SYSTEM
SETUP
GUIDE
TV CONTROL
INPUT
TV VOL
SELECT
DTV ON/OFF REC
TUNER
DISPLAY
MPX CH RETURN
AUDIO SUBTITLE
RECEIVER CONTROL
THX STANDARD
ACOUSTIC
AUTO SURR EQ
EFFECT
SHIFT
/CH SEL
RECEIVER
6 To program additional signals for the current
component repeat steps 4 and 5.
To program signals for another component, exit and
repeat steps 1 through 5.
7 Press the RECEIVER button to exit and store the
operation(s).
Note
• Some commands from other remote controls cannot
be learned, but in most cases the remotes just need
to be moved closer together or farther apart.
• If the remote LCD shows ERROR, it may also mean
the memory is full. See Erasing one of the remote
control button settings below to erase a programmed
button you're not using to free up more memory.
• TV CONTROL buttons (TV ,TV VOL +/–, TV CH +/–
and INPUT SELECT) can only be learned after
selecting TV CONT.
SOURCE
DVR/VCR TV CONT
TUNER RECEIVER
FL DIMMER SR
DISC
ENTER
CLASS
MENU
ST
ENTER
BAND
RETURN
TV CH VOL
DTV INFO MUTE
REC STOP
HDD DVD
CH CH
ADV.SURR STEREO
SIGNAL MIDNIGHT/
SELECT LOUDNESS
SLEEP DIALOG E
09
53
En