Controlling The Rest Of Your System; Setting The Remote To Control Other Components; Selecting Preset Codes Directly - Pioneer VSX-1015TX Operating Instructions Manual

09

Controlling the rest of your system

Chapter 9:
Controlling the rest of your system
Setting the remote to control other
components
Most components can be assigned to one of the MULTI
CONTROL buttons using the component's manufacturer
preset code stored in the remote.
However, please note that there are cases where only
certain functions may be controllable after assigning the
proper preset code, or the codes for the manufacturer in
the remote control will not work for the model that you
are using.
If you can't find a preset code that matches the
component you want to control, you can still teach the
remote individual commands from another remote
control (page 53).
Note
• TV codes (for example, codes for TV, CATV, Satellite
TV or DTV) can only be assigned to the TV/SAT or TV
CONT button.
• If you assign the TUNER function to another
component, you will have to reassign it to the Pioneer
preset code to use this receiver's built-in tuner.
• You can cancel or exit any of the steps by pressing
RECEIVER. To go back a step, press RETURN.
• After one minute of inactivity, the remote
automatically exits the operation.

Selecting preset codes directly

52
En
INPUT
RECEIVER SOURCE
SELECT
DVD/LD TV/SAT DVR/VCR TV CONT
MULTI CONTROL
CD CD-R/TAPE TUNER RECEIVER
INPUT ATT FL DIMMER SR
DISC
+10
ENTER
D.ACCESS CLASS
TOP MENU MENU
TUNE
ST ST
DTV MENU
ENTER
T.EDIT BAND
TUNE
SYSTEM
SETUP
GUIDE RETURN
TV CONTROL
INPUT
TV CH VOL
TVVOL
SELECT
1 While pressing the RECEIVER button, press and
hold the 1 button.
The remote LCD display shows SETUP.
2 Press the MULTI CONTROL button for the
component you want to control.
The LCD on the remote displays the component you want
to control.
• You can't assign the RECEIVER button.
3 Use (cursor left/right) to select PRESET
then press ENTER.
4 Use (cursor up/down) to select the first
letter of the brand name of your component then
press ENTER.
This should be the manufacturer's name (for example, P
for Pioneer).
5 Use (cursor up/down) to select the
manufacturer's name from the list then press ENTER.
6 Use (cursor up/down) to select the proper
code from the list, then try using this remote control
with your component.
The code should start with the component type (for
example, DVD 009). If there is more than one, start with
the first one.
To try out the remote control, switch the component on or
off (into standby) by pressing SOURCE
seem to work, select the next code from the list (if there
is one).
• If you can't find or properly enter a preset code, you
can still teach the remote individual commands from
another remote control (see Programming signals
from other remote controls below).
7 If your component is controlled successfully,
press ENTER to confirm.
The remote LCD display shows OK.
. If it doesn't