Choosing The Input Signal - Pioneer VSX-1015TX Operating Instructions Manual

Listening to your system

Choosing the input signal

You need to hook up a component to both analog and
digital inputs on the rear of the receiver to select between
input signals.
MPX CH RETURN
AUDIO SUBTITLE
RECEIVER CONTROL
THX STANDARD
ACOUSTIC
AUTO SURR EQ
EFFECT
SHIFT
/CH SEL
RECEIVER
TUNER
TUNING/ MIDNIGHT/
EDIT
STATION BAND MPX LOUDNESS
TUNER
MULTI
CONTROL
JOG
SYSTEM INPUT FL
SETUP RETURN ATT DIMMER
MULTI JOG
PHONES
• Press SIGNAL SELECT to select the input signal
corresponding to the source component.
Each press cycles through the options as follows:
• AUTO – This automatically switches to DIGITAL if a
digital source is detected, otherwise it remains on
ANALOG.
• ANALOG – Selects the analog inputs.
• DIGITAL – Selects the digital input.
When set to DIGITAL or AUTO, 2 DIGITAL lights with
Dolby Digital decoding, DTS lights with DTS decoding,
and WMA9 Pro lights to indicate decoding of a WMA9
Pro signal.
Note
• This receiver can only play back Dolby Digital, PCM
(32kHz–96 kHz), DTS and WMA9 Pro digital signal
formats (including DTS 96kHz/24 bit). With other
digital signal formats, set to ANALOG.
• You may get digital noise when a LD or CD player
compatible with DTS is playing an analog signal. To
prevent noise, make the proper digital connections
(page 16) and set the signal input to DIGITAL.
• Some DVD players don't output DTS signals. For
more details, refer to the instruction manual supplied
with your DVD player.
HDD DVD
CH CH
ADV.SURR STEREO
SIGNAL MIDNIGHT/
SELECT LOUDNESS
SLEEP DIALOG E
ACOUSTIC DIALOG MULTI CH SIGNAL EXTENDED
SPEAKERS
TONE EQ ENHANCEMENT IN SELECT MODE
MULTI
JOG
VIDEO2 INPUT
MCACC
SETUP MIC
DIGITAL IN S-VIDEO VIDEO L AUDIO R
05
35
En