Table of Contents
Advertisement
Safety Warnings Summary
Copyright © 2017, Juniper Networks, Inc.
[edit]
root@# set routing-options static route remote-prefix next-hop destination-ip retain
no-readvertise
Enable Telnet service.
10.
[edit]
root@# set system services telnet
NOTE:
When Telnet is enabled, you cannot log in to a PTX10000 through
telnet using root credentials. Root login is allowed only for SSH access.
Commit the configuration to activate it on the router.
11.
[edit]
root@# commit
This is a summary of safety warnings. For a complete list of warnings, including
translations, see
PTX10008 Hardware Guide
WARNING:
Failure to observe these safety warnings can result in personal
injury or death.
Permit only trained and qualified personnel to install or replace router components.
Perform only the procedures described in this quick start and the PTX10008 router
documentation. Other services must be performed only by authorized service personnel.
Before installing the router, read the planning instructions in the PTX10008 router
documentation to make sure that the site meets power, environmental, and clearance
requirements for the router.
Before connecting the router to a power source, read the installation instructions in
the PTX10008 router documentation.
A base AC configuration is 280 lb (127 kg) and redundant AC configurations can weigh
322 lb (146.06 kg). Installing the PTX10008 router in a rack or cabinet requires either
a mechanical lift or three people to lift the router and another person to secure it to
the rack. To prevent injury, keep your back straight and lift with your legs, not your back.
If the rack or cabinet has stabilizing devices, install them in the rack before mounting
or servicing the router in the rack or cabinet.
Before installing or after removing an electrical component, always place it
component-side up on a flat antistatic mat or in an electrostatic bag.
Safety Warnings Summary
at
http://www.juniper.net/techpubs/
.
33
Advertisement
Table of Contents
