Step 7-Connecting To The Network - Juniper PTX10008 Quick Start Manual

PTX10008 Router Quick Start Guide
Step 7–Connecting to the Network
30
Figure 25: Setting the Enable Switches for the Power Source
1— Source input 1
Verify that the input 1 and 2 LEDs on the power supply faceplate are lit and are on
19.
steadily.
Press the power switch to the on (
20.
You can configure and manage the PTX10008 by using a dedicated console. Every control
board has a console port with an RJ-45 connector. Use the console port to connect the
device to the management console or to a console server. The console port accepts a
cable with an RJ-45 connector.
Ensure that you have an Ethernet cable with an RJ-45 connector available. An RJ-45
cable and an RJ-45 to DB-9 serial port adapter are supplied with the device.
NOTE: If your laptop or PC does not have a DB-9 male connector pin and you
want to connect your laptop or PC directly to the device, use a combination
of the RJ-45 to DB-9 female adapter supplied with the device and a USB to
DB-9 male adapter. You must provide the USB to DB-9 male adapter.
To connect the PTX10008 to the network using the console port:
Connect one end of the Ethernet cable into the console port labeled
1.
board.
Connect the other end of the Ethernet cable into the console server.
2.
2— Source input 2
| ) position.
Copyright © 2017, Juniper Networks, Inc.
on the control
CON