JVC NX-F30B Service Manual page 12

(5) Take out the pickup assembly from traverse mechanism
chassis by order. (See Fig.11)
order 2
Caution:
When attach the tray assembly, boss of loading sub as-
sembly should attach to guide of bottom side at tray as-
sembly. (See Fig.15)
3.2.3 Removing the feed motor assembly (See Fig.12)
(1) Remove the one screw G attaching the feed motor assem-
bly.
(2) Remove the feed motor wires from solder part of spindle
motor board.
Solder part
Middle gear
Lead screw
1-12 (No.MB695<Rev.001>)
order 3
order 1
Fig.11
G
Fig.12
3.2.4 Removing the spindle motor assembly (See Fig.13)
(1) Remove the three screws H attaching the spindle motor
from spindle motor board.
H
Spindle motor
Fig.13