JVC NX-F30B Service Manual page 11

(5) Solder the solder part of DVD pick up. (See Fig.5)
(6) Disconnect the card wire from
DVD module board. (See Fig. 6)
Caution:
• Solder the short land section on the DVD pickup be-
fore disconnecting the card wire from the connector on
the DVD pickup. If the card wire is disconnected with-
out attaching solders, the pickup may be destroyed by
static electricity.
• When attaching the DVD pickup, be sure to remove
solders from the short land section after connecting
the card wire to the connector on the DVD pickup.
DVD module board
CN201
3.2.2 Removing the pickup assembly (See Fig.7 to 11)
(1) Remove the two rod springs pressing the guide shaft. (See
Fig.7)
ROD SPRING
(2) Remove the screw E and F attaching the spring holder.
See Fig.8)
Solder short land section
Fig.5
CN101 and CN201
CN101
Fig.6
ROD SPRING
Fig.7
on the
Spring holder
(3) Remove the read screw from traverse mechanism assem-
bly. (See Fig.9)
Middle gear
(4) Remove the bar spring pressing the shaft. (See Fig.10)
HOOK
F E
Fig.8
Lead screw
Fig.9
(SHAFT)
(T.TABLE)
(BAR SPRING)
Fig.10
(No.MB695<Rev.001>)1-11