Displays & Controls; Front Panel - Pioneer VSX-D710S Operating Instructions Manual

Displays & Controls
05

Front Panel

1
1 STANDBY indicator
Lights when the receiver is in standby mode (note
that the receiver consumes a small amount of power
(1W) in standby mode).
2
STANDBY/ON button
Switches the receiver between on and standby (note
that the receiver consumes a small amount of power
(1W) in standby mode).
3 STATION (+/–) buttons (see pages 32-33)
Selects station memories when using the tuner.
4 TUNING (+/–) buttons (see pages 32-33)
Selects the frequency when using the tuner.
5 DIRECT button
Use to switch DIRECT playback on or off. This mode
bypasses the tone controls, channel levels, 2/DTS
and DSP modes for the most accurate reproduction of
a program source.
6 MONITOR button
Press to switch tape monitoring on/off.
7 DIGITAL NR button (VSX-D810S/D850S)
Switches the DIGITAL NR on or off .
DVD5.1CH button (VSX-D710S) (see page 31)
On the VSX-D810S/D850S use this button to
switches the DIGITAL NR on or off. On the VSX-
D710S this button switches between DVD5.1CH
input and regular DVD input.
8 DSP MODE button (see page 28, 30)
Use to switch between the various DSP modes
available (
HALL1, HALL 2, JAZZ, DANCE,
THEATER1, THEATER 2, 6CH STEREO [VSX-
D810S/D850S only]
button to create different surround sound effects from
any stereo source.
9 Remote sensor
Receives the signals from the remote control.
0 SIGNAL SELECT button (see page 29)
Use to select an analog or digital or AUTO (VSX-
D810S/D850S only) signal.
- 2 /DTS button (see pages 27, 29)
22 Use to switch between the various Dolby/DTS
surround modes.
En
2
3
N∫m-Û˘,?∫
* & ^ %
(
) and
. Use this
DSP off
(VSX-D710S DVD5.1CH button)
7
4 5 6 8
9 0 -
@
$ #
= TONE button
This button allows you to activate the BASS &
TREBLE controls. To adjust the BASS and/or TREBLE
use the MULTI JOG DIAL. Tone can only be used in 2
channel stereo sound mode. The tones controls have
no effect on the B speaker system.
~ MULTI JOG dial
You can use this dial for two purposes. Firstly, in
normal mode turn it to select a source component.
Secondly, use it to adjust the BASS and/or TREBLE
levels when the TONE button has been activated (as
explained above).
! MASTER VOLUME
Use to set the overall listening volume.
@ VIDEO INPUT jacks
Connect a video camera, video game system, etc. to
the
VIDEO INPUT
# MIDNIGHT button (see page 31)
Use when listening to movie soundtracks at low volume.
This feature will enable you to hear quiet sounds and
not get jolted by loud or sudden sound effects.
$ SPEAKERS button
Use to switch the speaker system
. In
off B and A+B speaker modes you hear only 2 channel
stereo sound.
% MPX button (see page 32)
lf the
TUNED
tuning to an FM station because the signal is weak,
press the MPX button to switch the receiver into
mono reception mode. This should improve the
sound quality and allow you to enjoy the broadcast.
^ BAND button (see page 32-33)
Press to select the AM or FM band.
& MEMORY button (see page 33)
Press to memorize a station for recall using the
STATION (+/–)
* CLASS button (see pages 33)
Switches between the three banks (classes) of station
memories.
( PHONES jack
Use to connect headphones but this does not switch
the speakers off.
= ~
1
!
jacks (refer to page 10).
= =
A B
or indicators don't light when
STEREO
buttons.
=
A+B