Controlling The Rest Of Your System; Recalling Preset Codes - Pioneer VSX-D710S Operating Instructions Manual

Controlling the Rest of Your System

Recalling Preset Codes

The following steps show you how to recall preset codes
for each MULTI CONTROL button. Once the preset
code is assigned, pressing the button will automatically
set the remote to operate the respective component.
MEMO:
• Refer to "Preset Code List" on pages 43 to 49 for the
components and manufacturers available.
• Refer to "Controlling the Rest of Your System" on
pages 35 to 49 for detailed explanations on how to
operate your other components.
SOURCE
DVD TV VCR
MULTI CONTROL
RCV CD TUN
1 2
MIDNIGHT 5.1 / 7.1
4 5
EFFECT
7 8
10
0
DTV INFO MPX/RETURN D.ACCESS
¶ 3
7
BAND CLASS
DTV ON/OFF
1 ¡ 4
2
/DTS DSP TEST TONE
CH SELECT CH LEVEL
LOUDNESS
FL DIMMER SETUP
TUNE
ST
ENTER
TUNE
CHANNEL
VOLUME
MENU
TVFUNC
TV
TV CONTROL
AV PRE-PROGRAMMED AND LEARNING
REMOTE CONTROL UNIT
1 Press SETUP and hold for three seconds to
select the Preset mode.
The LED lights steadily for two seconds. (VSX-
D850S only: The LCD display shows SETUP.)
To cancel the preset mode at any time
Press .
SETUP
The remote control will also return to the previous
mode after thirty seconds of inactivity.
2 Press the MULTI CONTROL button for the
component you want to control.
Each button can be set to control one of the
following components
DVD DVD/LD player or DVD Recorder
TV TV, Satellite tuner or Cable TV tuner
VCR
VCR or Digital Video Recorder
CD
CD player
CD-R CD Recorder, Tape deck
or MD player
TVC
TV or Cable TV tuner
TUN FM/ AM tuner
RECEIVER
LED
CD-R
2
TVC
3
3
ATT
6
9
DISC
ENTER
GUIDE
8
DTV MENU
¢
SIGNAL SELECT
FUNCTION
1
MUTING
ST
MASTER VOLUME
3 Use the number buttons to enter the 4 digit
setup code. (see pages 43-49 for Preset Code
List)
The LED will blink for half a second after each digit
is input and will show a long, two second blink to
confirm a valid code has been input. (VSX-D850S
only: The code appears in the LCD display as you
input it. The display shows OK if it' s a valid code.)
If the LED blinks three times it means an invalid code
has been input or an error has occurred. Check the
preset code list and try again. If you are not able to
input a preset code you can refer to page 38 to teach
the remote control individual commands.
The remote control returns to the previous operation
mode. It will also return to the previous mode after
thirty seconds of inactivity.
4 Repeat steps 1 through 3 to assign preset
codes for as many components as necessary.
MEMO:
• You can only input a code for the component type
written on each MULTI CONTROL button.
• If you recall a preset code for the tuner (TUN MULTI
CONTROL), you will not be able to control the built-
in tuner of this receiver using the remote. To reset the
remote to the built-in tuner, input the preset code
7008.
• To erase the preset code for the current MULTI
CONTROL button, enter 0000 as the code in step 3.
09
35
En