Ipod Messages; Xm Radio Messages - Pioneer VSX-82TXS Operating Instructions Manual

Additional information
Symptom
No picture.
No sound, or sound suddenly
ceases.
Noisy or distorted picture.

iPod messages

Symptom Cause
Error I1 There is a problem with the signal path from the
iPod to the receiver.
Error I2 The software version being used with the iPod
needs to be updated.
No Track
There are no playable songs currently stored in
the iPod.

XM radio messages

Symptom Cause
Check Antenna The XM antenna is not connected.
XM ANT ERR A short-circuit occurring in the antenna or
surrounding antenna cable.
Updating The radio is being updated with the latest
encryption code.
No Signal The XM signal is too weak at the current location. n/a
Loading
The receiver is acquiring audio or program
information.
Off Air
The channel currently selected has stopped
broadcasting.
XM– – – You have selected a channel that does not exist,
or that you have not subscribed to.
– – – – – – – – There is no artist name/feature, song/program
title, or channel category associated with the
channel at this time.
Note
• If the unit does not operate normally due to external effects such as static electricity disconnect the power plug
from the outlet and insert again to return to normal operating conditions.
Remedy
• If your display device is not SD (480i) compatible then the 480i to HDMI converted video will not be
displayed. In this case, connect using the component, S-video or composite video jacks.
• Depending in the output settings of the source component, it may be outputting a video format that can't
be displayed. Change the output settings of the source, or connect using the component, S-video or
composite jacks.
• Try changing the Resolution setting (in Setting the AV options on page 66).
• Check that the HDMI AV setting is set to AMP/THROUGH.
• If the component is a DVI device, use a separate connection for the audio.
• If analog video is being output over HDMI then there will be no HDMI audio output. Please use a separate
connection for the audio.
• Check the audio output settings of the source component.
• Sometimes a video deck may output a noisy video signal (during scanning, for example), or the video
quality may just be poor (with some video game units, for example). The picture quality may also depend on
the settings, etc. of your display device. Switch off the video converter and reconnect the source and display
device using the same type of connection (component, S-video or composite), then start playback again.
• If the problem still persists when connecting your HDMI component directly to your monitor, please
consult the component or monitor manual or contact the manufacturer for support.
Action
Switch off the receiver and reconnect the iPod to the receiver.
If this doesn't seem to work, try resetting your iPod.
Update the software being used with the iPod (software
versions prior to iPod update 2004-10-20 are not supported).
Input some music files compatible with iPod playback.
Action
Check that the XM antenna cable is attached securely.
Make sure that there is nothing unusual with the antenna or
antenna cable. Switch the power off then back on again.
Wait until the encryption code has been updated. Channels
00 and 01 should function normally.
Wait until the information has been received.
Select another channel.
The receiver will automatically switch to channel 001 (or the
last selected channel).
No action needed.
12
83
En