Playing Sources With Dolby Digital Or Dts Sound - Pioneer VSX-609RDS Operating Instructions Manual

Sound Modes
Before operating the receiver, be sure to press the main power button on the front panel to turn the
power ON (_).

Playing Sources with Dolby Digital or DTS Sound

VSX-709RDS
SOURCE RECEIVER
DVD TV VCR
MULTI CONTROL
4
RCV CD TUN
1 2 3
MIDNIGHT 5.1CH ATT
4 5 6
5
SIGNAL SELECT EFFECT
7 8 9
+10 0 DISC
TV CONTROL
TV
TV VOL TVFUNC MASTER VOLUME
MENU
2
6 2
DSP TEST TONE
CH SELECT CH LEVEL FL DIMMER
3
LOUDNESS FUNCTION MUTING SETUP
VSX-609RDS
Î
MULTI CONTROL
DVD/LD TV/SAT VCR/DVR CD
4
CD-R/
RECEIVER TUNER TV CONT
TAPE/MD
6
2
DSP MODE MIDNIGHT 5.1CH
1 2 3 4
CHANNEL TEST SIGNAL
SELECT TONE ATT SELECT
5 6 7 8
2
CHANNEL
EFFECT
LEVEL
9 0
10 DISC
CH
FUNC
TV CONTROL
VOL VOL
FQ
ST ST
ENTER
TOP
MENU MENU
FQ
SOURCE CLASS MPX BAND
7 8 3
CHANNEL
D.ACCESS
DISPLAY RF ATT
1 ¡ 4 ¢
3
LOUDNESS FUNCTION MUTING
FL REMOTE MASTER
2
RECEIVER DIMMER SETUP VOLUME
AUDIO/VIDEO PRE-PROGRAMMED
REMOTE CONTROL UNIT
2 3
When playing LD recorded in Dolby Digital
When connecting a DVD/LD player or LD player using the
demodulator (RFD-1) is required. The RF demodulator changes the RF signal to a digital signal which
is then processed by the receiver at the digital input jacks. For more details, refer to the instruction
manual supplied with the RFD-1.
38
En
1 Turn on the power of the playback
2
component.
3
CD-R
TVC
2 Press RECEIVER
receiver.
Be sure that the standby indicator turns off on the front panel.
3 Press a MULTI CONTROL button or the
8
FUNCTION button to select the source you
want to playback.
If the Direct function is OFF you have to use the FUNCTION button
to select the source (see p.26).
Î 4 Press RCV (VSX-709RDS) or RECEIVER (VSX-
609RDS).
This set the remote control to select the sound mode.
5 Press SIGNAL SELECT to select DIGITAL.
(Refer to "Switching ANALOG/DIGITAL Signal Input" on page 36.)
3
6 Press
5
mode on.
7 Start playback of the component you selected
in step 1.
8 Press MASTER VOLUME (+/–) to adjust the
volume level.
8
8 6
to turn on the power of the
2
to switch the Dolby Digital/DTS
• When an LD or CD player compatible with
DTS is played back with SIGNAL SELECT
5
set in "ANALOG", digital noise is output
caused by playing back the DTS directly (no
decoding). To prevent noise, you need to
make digital connections (Refer to page 9)
and set SIGNAL SELECT to "DIGITAL".
2
RF output, a commercially available RF