Pioneer VSX-609RDS Operating Instructions Manual page 24

Preparations
Learning mode: Programming signals from other remote controls
(VSX-709RDS only)
If preset codes are not available for your component(s), or the available preset codes do not operate correctly,
you can use this function to program in signals from the remote control(s) of your other component(s). This
operation can also be used after recalling a preset code to program additional operations not covered in the
preset codes.
SOURCE RECEIVER
DVD TV VCR
MULTI CONTROL
RCV CD TUN
1 2
MIDNIGHT 5.1CH ATT
4 5
2
SIGNAL SELECT EFFECT
7 8
0
+10 DISC
TV CONTROL
TV
TV VOL TVFUNC MASTER VOLUME
MENU
CHANNEL
FQ
ST ST
ENTER
FQ
8
D.ACCESS BAND CLASS
3
1 ¡
MPX DISPLAY RF ATT
7
4 ¢
2
DSP TEST TONE
CH SELECT CH LEVEL FL DIMMER
LOUDNESS FUNCTION MUTING SETUP
The highlighted buttons
can learn new functions
SOURCE
DVD TV
MULTI CONTROL
RCV CD
1
MIDNIGHT
4
SIGNAL SELECT
7
+10
TV CONTROL
TV VOL
CHANNEL
ST
8
D.ACCESS
3
MPX
7
2
DSP
CH SELECT CH LEVEL
LOUDNESS FUNCTION
24
En
LED
1 Press SETUP and hold for three seconds.
The LED will blink twice.
CD-R
2
TVC
2 Press the MULTI CONTROL button for the
3 2
component you want to control and then
6
2
press 9, 7, 5 to select the Learning setup
9
mode. The remote control is ready to learn
new commands from other remote controls.
The LED flashes rapidly
(
To cancel Learning setup mode
Press SETUP button.
After ten seconds if no commands are entered the remote
control will revert to its previous mode.
3 Press the button to be programmed (for
example the 3 [play] button).
4 Point the remote controls at each other, about
2 – 5 cm apart, and press the button on the
1,5
other remote control for the operation you
Î
want to program .
1 Point the remote controls toward each other.
2 Press the button on the other remote control corresponding to the
operation you wish to program. The LED on this receiver's remote
will go out and then blink twice when the operation is learned.
Press the teaching button repeatedly, varing the distances
RECEIVER
between the remote, until you see this receiver's remote blink
VCR CD-R
twice indicating the operation has been learned.
TUN TVC
2 3
5.1CH ATT
5 6
EFFECT
8 9
To program additional operations for the current component
0
DISC
Repeat steps 3 and 4.
TV To program operations for another component
Repeat steps 2 through 4.
TVFUNC MASTER VOLUME
MENU
5 Press SETUP to exit the Learning setup mode.
After ten seconds of inactivity the remote control will automatically
FQ
ST leave the Learning mode and revert to its previous mode.
ENTER
FQ
BAND CLASS
1 ¡
DISPLAY RF ATT
4 ¢
TEST TONE
FL DIMMER
MUTING SETUP
2 – 5 cm
Some commands from other remote controls cannot be learned,
but in most cases the remotes just need to be moved closer
together or farther apart.
)