Direct Function - Pioneer VSX-609RDS Operating Instructions Manual

Preparations

Direct Function

The Direct function is a useful feature which allows you to keep the receiver in one function (for example, CD)
while putting the remote control in a different function. This could let you, for example, use the remote control
to setup and listen to a CD on the receiver and then use the remote control to rewind a tape in your VCR while
you continue to listen to your CD player.
When the Direct function is ON any MULTI CONTROL button you press will change the function of both the
receiver and the remote control. When you turn the Direct function OFF, you can operate the remote control
without affecting the receiver. Thus you could switch the remote control to the VCR and operate that
component while the receiver plays a different component.
SOURCE RECEIVER
DVD TV VCR CD-R
MULTI CONTROL
RCV CD TUN TVC
1 2 3
MIDNIGHT 5.1CH ATT
4 5 6
SIGNAL SELECT EFFECT
7 8 9
0
+10 DISC
TV CONTROL
TV
MPX DISPLAY RF ATT
7
4 ¢
2
DSP TEST TONE
CH SELECT CH LEVEL FL DIMMER
LOUDNESS FUNCTION MUTING SETUP
Î
SOURCE RECEIVER
DVD TV VCR CD-R
MULTI CONTROL
RCV CD TUN TVC
1 2 3
MIDNIGHT 5.1CH ATT
4 5 6
SIGNAL SELECT EFFECT
7 8 9
+10 0
DISC
TV CONTROL
TV
MPX DISPLAY RF ATT
7
4 ¢
2
DSP TEST TONE
CH SELECT CH LEVEL FL DIMMER
LOUDNESS FUNCTION MUTING SETUP
Î
Î
MULTI CONTROL
DVD/LD TV/SAT VCR/DVR CD
CD-R/
RECEIVER TUNER TV CONT
TAPE/MD
2
DSP MODE MIDNIGHT 5.1CH
1 2 3 4
CHANNEL TEST SIGNAL
ATT
SELECT TONE SELECT
5 6 7 8
CHANNEL
EFFECT
LEVEL
‡
9 0
ENTER
1 ¡ 4 ¢
LOUDNESS FUNCTION MUTING
FL REMOTE MASTER
RECEIVER
DIMMER SETUP VOLUME
AUDIO/VIDEO PRE-PROGRAMMED
REMOTE CONTROL UNIT
26
En
LED
2
VSX-709RDS
MULTI
CONTROL
To set a MULTI CONTROL button to Direct OFF:
1 Press SETUP and hold for three seconds.
9
The LED will blink twice.
3
8
3
2 Press the MULTI CONTROL button which you
want to set to OFF.
3 Press 9, 8, 3.
1
The LED blinks twice to indicate the button has been set.
LED
To set a MULTI CONTROL button to Direct ON:
2
MULTI
1 Press SETUP and hold for three seconds.
CONTROL
The LED will blink twice.
2 Press the MULTI CONTROL button which you
9
3
want to set to ON.
8
2
3 Press 9, 8, 2.
The LED blinks twice to indicate the button has been set.
1
VSX-609RDS
MULTI
1 To turn the Direct funtion OFF (the default
CONTROL
setting is ON), press REMOTE SETUP and
number button 3 at the same time.
1
3
2
2 2 To turn the the Direct function ON (if you have
turned it off), press REMOTE SETUP and
number button 2 at the same time.
1,2
TVC doesn't have this feature and thus can't use the Direct func-
tion.
TV CONT doesn't have this feature and thus can't use the Direct
function.