The Input Assign Menu; The Other Setup Menu; Dynamic Range Control Setup - Pioneer VSX-415-S/-K Operating Instructions Manual

The System Setup menu

The Input Assign menu

You only need to make this setting if you didn't
hook up your digital equipment according to
the default settings for the digital inputs (see
below). This setting tells the receiver what
digital equipment is hooked up to which
terminal so the buttons on the remote
correspond to what you have hooked up.
• DIG. IN default settings:
COAX 1 (coaxial) – DVD
COAX 2 (coaxial) – CD
OPT 1 (optical) – TV
1 Select 'IN ASSIG.' from the System Setup
menu.
See Making receiver settings from the System
Setup menu on page 44 for more on this.
2 Select DIG. IN from the IN ASSIG. menu.
3 Select the number of the digital input to
which you've connected your digital
component.
The numbers correspond with the numbers
beside the inputs on the back of the receiver.
4 Select the component that corresponds
with the one you connected to that input.
Select DVD, TV, CD, CDR, DVR or OFF.
• Use the (cursor up/down) buttons
and ENTER to do this.
• If you assign a digital input to a certain
function (for example, DVD) then any
digital inputs previously assigned to that
function will automatically be switched off.
5 When you're finished, press RETURN.

The Other setup menu

The Other menu is where you can make
customized settings to reflect how you are
using the receiver.
1 Select OTHER from the System Setup
menu.
See Making receiver settings from the System
Setup menu on page 44 for more on this.
2 Use (cursor left/right) to select the
setting you want to adjust then press ENTER .
If you are doing this for the first time, you may
want to adjust these settings in order:
• DRC – Specify the amount of dynamic
range adjustment to Dolby Digital
soundtracks (see Dynamic Range Control
Setup below).
• DUALMONO – Isolate one channel when
listening to discs with dual mono encoding
(see Dual Mono Setup below).
• LFE ATT – Set the attenuator level for the
LFE channel (LFE Attenuator Setup below).
3 Make the adjustments necessary for each
setting, pressing RETURN to confirm after
each screen.

Dynamic Range Control Setup

• Default setting: OFF
This setting specifies the amount of dynamic
range adjustment to Dolby Digital and DTS
movie soundtracks. You may want to use this
when listening to surround sound at low
volumes.
1 Select DRC from the OTHER setup menu.
2 Use (cursor up/down) to choose the
setting that you want.
• OFF – No dynamic range adjustment (use
when listening at higher volume).
• MID – Mid setting.
08
51
En