Pioneer VSX-415-S/-K Operating Instructions Manual page 60

11 Additional information
Problem
When a search is performed
by a DTS compatible CD
player during playback, noise
is output.
Everything seems to be set up
correctly, but the playback
sound is odd.
There seems to be a time lag
between the speakers and the
output of the subwoofer.
After using the Auto MCACC
Setup, the speaker size
setting (LARGE or SMALL) is
incorrect (VSX-515 model
only).
Can't operate the remote
control.
The display is dark or off.
60
En
Remedy
• This is not a malfunction, but be sure to turn the volume down to
prevent the output of loud noise from your speakers.
• Check that the positive/negative speaker terminals on the receiver
are matched with the corresponding terminals on the speakers.
Refer to page 21 (VSX-415) or page 22 (VSX-515).
• VSX-415 model only – You may need to decrease the
distance setting
on page 42
.
subwoofer output
• VSX-515 model only – See Automatically setting up for surround
sound (MCACC) on page 13 to set up your system again using
MCACC (this will automatically compensate for a delay in the
subwoofer output).
• Low-frequency noise could have been caused by an air conditioner
or motor. Switch off all appliances in the room and rerun the Auto
MCACC Setup.
• Replace the batteries (refer to page 6).
• Operate within 7 m, 30° of the remote sensor on the front panel
(refer to page 6).
• Remove the obstacle or operate from another position.
• Avoid exposing the remote sensor on the front panel to direct light.
• Press FL DIMMER on the remote control repeatedly to return to
the default.
to compensate
for a delay in the
Subwoofer