Introduction; User Guidelines - Siemens SITRANS F M MAG 8000 Operating Manual

MAG 8000 & MAG 8000 CT
1.

Introduction

1.1 User guidelines

1. Introduction
For safety reasons it is important that the following points, especially those marked with a warning
sign, are read and understood before the system is installed:
•
Installation, connection, commissioning and service must be carried out by personnel who
are qualified and authorized to do so.
•
It is very important that all personnel working with the equipment have read and understand
the instructions and directions provided in this manual and that they follow the instructions
and directions before taking the equipment into use!
•
Only personnel authorized and trained by the owner of the equipment may operate the
equipment.
•
Installation personnel must ensure that the measuring system is correctly connected in
accordance with the connection diagram.
•
For applications involving high working pressures or media that can be dangerous to
people, surroundings, equipment or other in the event of pipe fracture, Siemens recommends
taking precautions such as special placement, shielding or installation of a safety guard or
safety valve prior to installation of the sensor.
•
Repair and service may be performed by approved Siemens Flow Instruments personnel
only.
MAG 8000 or MAG 8000 CT configuration is made via a PC with an IrDA interface and the
configuration software program Flow Tool.
Parameters or data are in the following manual identified with an „FT" in front of the number, where
the information is stored.
The Flow Tool program can bee downloaded from the internet www.siemens.com/flow navigate
to Tools & downloads or order on a CD rom - see accessories in section 9.1.
SFIDK.PS.026.D9.02
3