Resetting The Main Unit; Switching The Speaker Impedance - Pioneer VSX-1014TX Operating Instructions Manual

12 Additional information

Resetting the main unit

Use this procedure to reset all the receiver's settings to
the factory default. Use the front panel controls to do this.
1 Switch the receiver into standby.
2 While holding down the TONE button, press and
hold the STANDBY/ON button for about three
seconds.
3 When you see RESET? appear in the display,
press ENTER.
OK? shows in the display.
4 Press SYSTEM SETUP to confirm.
OK appears in the display to indicate that the receiver
has been reset to the factory default settings.
70
En

Switching the speaker impedance

We recommend using speakers of 8Ω with this system,
but it is possible to switch the impedance setting if you
plan to use speakers with a 6Ω impedance rating.
• With the receiver in standby, press
ON while holding down the SPEAKERS button.
Each time you do this, you switch between the
impedance settings:
• SP 6 OHM – Use this setting if your speakers are
rated at 6Ω.
• SP 8 OHM – Use this setting if your speakers are
rated at 8Ω or more.
STANDBY/