C200H High-Density I/O Units (Special I/O Units) - Omron SYSMAC CS Series Operation Manual

C200H High-density I/O Units (Special I/O Units)

3-7

C200H High-density I/O Units (Special I/O Units)

Models
Name
TTL Input Unit 5 V DC, 32 inputs
DC Input Unit 24 V DC, 32 inputs
TTL Output Unit 5 V DC, 32 outputs
Transistor Output Unit 24 V DC, 32 outputs
TTL I/O Unit 5 V DC, 16 inputs/16 outputs
DC Input/Transistor 12 V DC, 16 inputs/16 outputs
Output Unit
24 V DC, 16 inputs/16 outputs
Components and Switch Settings
234
C200H High-density I/O Units are classified as C200H Special I/O Units.
Specifications
Note Immediate refreshing (!) is not possible for C200H High-density I/O Units, but
refreshing using IORF (097) is possible.
24-pin I/O wiring
connectors × 2
Note 1. Be sure to turn OFF the power supply to the PLC before setting the unit
number.
2. Set the unit number using a flat-blade screwdriver.
3. Do not stop in the middle of setting the value (between 0 and 9) or the set-
ting will not be complete.
4. Make sure that the groove in the unit number setting switch does not be-
come damaged.
Model Dynamic I/O mode
C200H-ID501 ---
C200H-ID215 ---
C200H-OD501 128 outputs
C200H-OD215 128 outputs
C200H-MD501 128 inputs
C200H-MD115 128 inputs
C200H-MD215 128 inputs
Section 3-7
Static I/O mode
High-speed inputs
High-speed inputs
---
---
High-speed inputs
High-speed inputs
High-speed inputs
Unit lock notch
Model label
I/O indicators
Unit number setting switch
Set the unit number between 0 and
9. Ten words are allocated per Unit
in the Special I/O Unit Area (words
2000 to 2959) according to the unit
number setting.