Swapping Your Current Location Time And Dual Time Settings; Stopwatch; Measuring; Measuring A Split Time - Casio QW 5513 Operation Manual

Swapping Your Current
Location Time and Dual Time
Settings
You can swap the time in your current location
with the Dual Time by holding down (B) for
about three seconds.
Pressing (B) will cause illumination to turn
●
on. Keep the button depressed for three
seconds.
Before swapping After swapping
Current location time Dual Time
Dual Time Current location time
Note
If you are using the small hour and
●
minute hands for Dual Time, only the
time in your current location will be
swapped with Dual Time. Dates are
not swapped.

Stopwatch

The stopwatch can measure elapsed time up
to 23 hours, 59 minutes, 59 seconds.
Note
If an ongoing elapsed time
●
measurement operation continues
for 24 hours, the measurement will
stop and the stopwatch will reset to
all zeros automatically.
Getting ready
Perform this procedure in the Stopwatch
Mode.
Navigating Between Modes
l
Stopwatch Mode
Operation Guide 5513

Measuring

Minutes
1.
Use the operations below to measure
elapsed time.
2.
Press (D) to reset the elapsed time to all
zeroes.
3.
Press (A) three times to return to the
Calendar Mode.

Measuring a Split Time

Minutes
1.
Use the operations below to measure
elapsed time.
Each press of (D) causes the elapsed
●
time up to that point (split time) to be
indicated for 5 seconds.
2.
Press (D) to reset the elapsed time to all
zeroes.
3.
Press (A) three times to return to the
Calendar Mode.
Seconds
24-hour
Hours
B
Start
B
Stop
B
Resume
B
Stop
Seconds
24-hour
Hours
B
Start
D
Split
B
Stop
Note
Up to 100 split times can be measure
●
during a single elapsed time
operation.

Timer

The timer counts down from a start time
specified by you. A beeper sounds when the
end of the countdown is reached.
The beeper is muted in the cases described
●
below.
When battery power is low
ー
Getting ready
Perform this procedure in the Timer Mode.
Navigating Between Modes
l
Timer Mode

Setting the Time

1.
Pull out the crown to the first click.
2.
Rotate the crown to change the
countdown start time setting.
The countdown start time can be set in
●
1-minute units up to 24 hours.
24-hour
Seconds
Hours Minutes
3.
Push the crown back in.
Note
You can set a countdown start time
●
of 24 hours by aligning the small 24-
hour hand with 24.
Crown
12