Dual Time; Configuring Dual Time Settings; Swapping Current Location Time And Dual Time; Alarms And Hourly Time Signal - Casio 5641 Operation Manual

Dual Time

Dual Time lets you look up the current time in
various time zones around the globe.
Configuring Dual Time
Settings
Dual Time lets you set the current time in
another time zone in addition to your current
location time.
1.
Enter the Dual Time Mode.
Navigating Between Modes
l
2.
Hold down (A) for at least two seconds.
This causes the hours digits to flash.
Hours
3.
Use (E) and (B) to change the hour setting.
4.
Press (D).
This causes the minutes digits to flash.
Minutes
5.
Use (E) and (B) to set the minute setting.
You can change the setting in 15-
●
minute increments.
6.
Press (A) to complete the setting
operation.
Watch Operation Guide 5641
Swapping Current Location
Time and Dual Time
1.
Enter the Dual Time Mode.
Navigating Between Modes
l
2.
Hold down (C) for at least two seconds.
This swaps your current location time with
your Dual Time.
Before swapping
Current location time
Dual Time
Note
This function comes in handy when
●
you need to move to another time
zone. For details about how to use it,
go to the section below.
Moving Between Time Zones
l
Alarms and Hourly
The watch will beep when an alarm time is
reached. You can set up to five different
alarms. The hourly time signal causes the
watch to beep every hour on the hour.
The beeper will not sound if battery power
●
is low.
After swapping
Dual Time
Current location time
Time Signal

Configuring Alarm Settings

1.
Enter the Alarm Mode.
Navigating Between Modes
l
2.
Press (C) to scroll through alarm numbers
([-1] to [-5]) until the alarm you want to
configure is displayed.
Alarm number
3.
Hold down (A) for at least two seconds.
This causes the hours digits to flash.
Hours
4.
Use (E) and (B) to change the hour setting.
If you are using 12-hour timekeeping,
●
[P] indicates p.m.
5.
Press (D).
This causes the minutes digits to flash.
Minutes
6.
Use (E) and (B) to set the minute setting.
7.
Press (A) to complete the setting
operation.
This causes the segment
●
corresponding to the alarm you turned
on to appear in the Graphic Indicator B.
Alarm 1
Alarm 2
Alarm 3
Alarm 4
Alarm 5
20