Configuring Dual Time
Settings
In addition to the current time in your location,
you can use Dual Time to set a time in another
zone, etc.
Dual Time seconds are synced with the
●
Timekeeping Mode seconds.
1.
Enter the Dual Time Mode.
Navigating Between Modes
l
2.
Hold down (A) for at least two seconds.
Release the button when the hour and
minute setting starts to flash.
This enters the setting mode. The
●
hands automatically shift out of the way
for easy viewing of the screen.
3.
Use (B) and (D) to change the hour and
minute setting.
Each press of either button changes the
●
setting in 15-minute units.
Holding down (B) or (D) scrolls through
●
settings at high speed.
If you are using 12-hour timekeeping,
●
[P] indicates p.m.
4.
Press (C).
5.
Press (D) to toggle summer time between
on and off.
[OFF]
●
The watch always indicates standard
time.
[ON]
●
The watch always indicates summer
time.
Watch Operation Guide 5692
6.
Press (A) to exit the setting screen.
[DST] appears whenever the display
●
current time is summer time.
Note
While the setting is being configured,
●
the watch will exit the setting operation
automatically after about two or three
minutes of non-operation.
Swapping Current Local
Time and Dual Time
1.
Enter the Dual Time Mode.
Navigating Between Modes
l
2.
Hold down (D) for at least two seconds.
Holding down (D) for at least two seconds
toggles between the Timekeeping Mode
time and the Dual Time.
Dual Time
The watch will beep when an alarm time is
reached. You can set up to five different
alarms. The hourly time signal causes the
watch to beep every hour on the hour.
Configuring Alarm Settings
1.
Enter the Alarm Mode.
l
2.
Use (B) and (D) to select the alarm ([1] to
[5]) whose setting you want to change.
Timekeeping Mode
Time
3.
Hold down (A) for at least two seconds.
Release the button when the hour setting
starts to flash.
Alarm
Navigating Between Modes
Alarm time
Alarm number
This enters the setting mode. The
●
hands automatically shift out of the way
for easy viewing of the screen.
While the setting is being configured,
●
the watch will exit the setting operation
automatically after about two or three
minutes of non-operation.
Alarm hour
10