Printer (Option) - Furuno FELCOM18 Installation Manual

1. MOUNTING
3) Refasten two screws removed at step 1) to fix the clamp.
Unfasten these screws.
4) Run the interconnection cable thorough a cable entrance and connect it to ter-
minal board.
Flush mount
The optional flush mounting kit OP16-27 (Code No.: 004-448-000) is required.
Name
Fixture
Pan head screw
Self-tapping screw
1. Make a cutout in the mounting location, referring to the outline drawings at the
back of this manual.
2. Fix the unit to the fixture with four pan head screws (supplied).
3. Fasten four self-tapping screws (φ5, supplied) to fasten the fixture to the mounting
position.
1.4

Printer (option)

Mount the printer (PP-510 or PP-520)
on a tabletop with the fixtures sup-
plied. Refer to the outline drawing at
the end of this manual for the mount-
ing dimensions. The right figure is for
PP-520
1. Decide the location of the printer.
2. Set the ink ribbon cartridge and
the roll paper to the printer.
3. Set the fixtures (left/right) onto
the printer. Fasten them with four
self-tapping screws (φ5x20).
1-6
Rotate.
Type
16-018-4201-1 100-317-841
M3x6 000-800-362
4x16 000-162-605-10
Refasten screws.
Code No. Qty
1
4
4
405
200