Demo Mode Function - Saeco Incanto HD8911 User Manual

English
28
Problem
The coffee comes out
slowly.
The frothed milk is too
cold.
The milk does not froth.
There is water under the
machine.

Demo mode function

Cause
The coffee dispensing spout is dirty.
The coffee is grind too finely.
The brew group is dirty.
The coffee exit duct is blocked.
The machine circuit is blocked by
limescale.
The cups are cold.
The classic milk frother is dirty or not
assembled correctly.
The type of milk used is not suitable
for frothing.
The drip tray is too full and
overflowed.
The machine is not placed on a
horizontal surface.
The machine is equipped with a demo mode function.
1 Press and hold the standby button for more than 8 seconds to enter the
demo mode function.
2 To exit the demo mode, turn the machine OFF and ON using the main
switch at the back of the machine.
Solution
Clean the coffee dispensing spout
and its holes with a pipe cleaner.
Use a different coffee blend or
adjust the grinder.
Clean the brew group.
Clean the coffee exit duct with the
handle of the multifunctional tool
or a spoon handle.
Descale the machine.
Preheat the cups by rinsing them
with hot water.
Clean the classic milk frother and
make sure it is correctly
assembled.
Different types of milk result in
different amounts of froth and
different froth qualities. We have
tested the following milk types
which proved to deliver a good
milk froth result: semi-skimmed or
full-fat cow's milk, soy milk and
lactose-free milk. Other types of
milk have not been tested and
may result in a small amount of
milk froth.
Empty the drip tray when the 'drip
tray full' indicator pops up through
the drip tray. Always empty the
drip tray before you start descaling
the machine.
Place the machine on a horizontal
surface so that the 'drip tray full'
indicator works properly.