Descaling Procedure - Saeco Incanto HD8911 User Manual

English
22

Descaling procedure

START
CALC
CLEAN
REMOVE
FILTER
When the display shows 'START CALC CLEAN', you need to descale the
machine. If you do not descale the machine when this message appears on
the display, the machine stop working properly. In that case, repairs are not
covered by the warranty.
Only use Saeco descaling solution to descale the machine. Saeco descaling
solution is designed to ensure optimal performance of the machine. The use
of other products may damage the machine and leave residues in the water.
You can buy Saeco descaling solution in the online shop at
www.shop.philips.com/service. The descaling procedure lasts 30 minutes
and consists of a descaling cycle and a rinsing cycle. You can pause the
descaling or rinsing cycle by pressing the ESC button. To continue the
descaling or rinsing cycle, press the OK button.
Note: Do not remove the brew group during the descaling
procedure. Warning: Do not drink the descaling solution or the
water dispensed during the descaling procedure.
1 Remove the drip tray and the coffee grounds container, empty and clean
them and put them back into place.
2 Remove the external part of the classic milk frother.
3 Place a large container (1.5 l) under the coffee dispensing spout and the
classic milk frother.
4 When the display shows 'START CALC CLEAN', press the OK button to
start the descaling procedure. Remove the hot water dispensing spout if
present.
-
The following icon on the display reminds you to remove the Intenza+
water filter.
Note: You can press ESC to skip descaling. If you want to start the
descaling procedure later, press the MENU button, select MENU and
scroll to select DESCALING. Press OK to confirm.
5 Remove the water tank. If present, remove the Intenza+ water filter from
the water tank and replace it with the original small white filter.