AEG L82470BI User Manual page 31

16-22 mm
Ø 35 mm
14 mm
595-598 mm
2
1
A
B
Door
The dimensions of the door should be:
• width 595 - 598 mm
• thickness 16-22 mm
X
• the height X depends on the height of the
adjacent furniture's base.
416
mm
22±1,5 mm
Hinges
To mount the hinges it is necessary to drill
two holes (dia. 35 mm, depth12.5-14 mm
depending on the depth of door furniture) on
the inner side of the door.
The distance between the holes hobs fixing
centres must be 416 mm. The distance from
upper edge of the door to the centre of the
hole depends on the adjacent furniture's
dimensions.
The hinges will be fixed to the door by means
of screws for wood 1 and 2 supplied with the
appliance.
Mounting the door
Fix the hinges to the appliance by means of
the M5x15 screws.
The hinges can be adjusted to compensate
for possible uneven thickness of the door.
To align the door perfectly it is necessary to
loosen the screw , adjust the door and
tighten the screw A again.
Counter-magnet
A
B
The appliance is prearranged for a magnetic
closure of the door. To enable a correct
operation of this device, it is necessary to
screw the counter-magnet A (steel disk +
C
rubber ring) in-to the inner side of the door.
Its position must correspond to the magnet B
on the appliance.
WARNING!
Do not remove the screw B.
WARNING!
Do not remove the screw B.
ENGLISH 31