Interface Mode; Entering Interface Mode; Enabling Interface Card Configuration - SATO S8400 Operator's Manual

Table of Contents

Section 3: Configuration and Operation

3.6 INTERFACE MODE

In this mode, you can set various parameters governing the use of interface cards. Due to the

wide range of interface cards available, only the default interface configuration settings are

covered in this section. A flowchart overview of advanced settings for all the optional interface

cards is included at the end of this chapter, and a detailed discussion of advanced settings can

be found in the Service Manual available upon request.

1. Press the LINE button to take the printer OFFLINE.

2. Press ENTER. The ONLINE MODE screen appears.

3. Press the

"INTERFACE MODE", then press ENTER to perform the first

setting. At any time within this mode, pressing CANCEL takes

you back one screen. Pressing the FUNCTION button returns

you immediately to the main Interface Mode screen.

The first setting in the Interface Mode lets you select whether you

wish to configure an interface card.

If NO is selected, the next screen is IGNORE CR/LF (Section

3.6.3). Press the

default setting is NO. Press the ENTER button to confirm the NO

setting and proceed to the next screen (see either Section 3.6.3 or

3.6.4 on the next page).

If YES is selected, the next screen lets you select an interface card to configure.

Depending on which interface card is installed, and which settings are active, a wide range of

possible screens may appear. Refer to page 3-35 to page 3-44, for detailed flowcharts of the all

settings and LCD screen menus available for LAN/Wireless LAN, IEEE1284, RS-232C, Parallel

and USB..

Page 3-10

arrow buttons until you see

buttons to select either YES or NO. The

S8400 Series Operator's Manual

Table of Contents