System Mode - SATO WS408TT-STD Owner's Manual

1 Introduction
Red **Orange
Red Red

1.4.2 System mode

The system mode consists of status light color combinations. It contains a
list of commands for you to select and run.
To enter the system mode and run the command, do the following:
1. Turn off the printer.
2. Press and hold the FEED button, and turn on the printer.
3. Both status lights glow solid orange for a few seconds. Next, they turn to
green shortly, and then turn to other colors.
4. When status lights show the color combination you need, release the
FEED button immediately.
5. Press the FEED button to run the command.
The following table is the command list of the system mode.
LED 1
Green
Green
Red
Red
Red
Orange
Orange
Cutter error (with optional cutter).
Cover (Thermal Head) open error during printing.
LED 2 Command
Red Transmissive Sensor Calibration
Orange Reflective Sensor Calibration
Red Resetting Your Printer
Orange Reserved
Green Disable Checking RTC Battery Charge
Red Reserved
Green Self Test and Dump Mode
8
Printer lights
V
(Section 3.1)
(Section 3.1)
(Section 3.3)
(Section 3.2)