Disabling The Vxlan Feature Globally; Vxlan Troubleshooting Commands; Vsm Commands - Cisco Nexus 1000V Troubleshooting Manual

VXLAN Troubleshooting Commands

S e n d d o c u m e n t c o m m e n t s t o n e x u s 1 k - d o c f e e d b a c k @ c i s c o . c o m .

Disabling the VXLAN Feature Globally

As a safety precaution, do not use the no feature segmentation command if there are any ports associated
with a VXLAN port profile. You must remove all associations before you can disable this feature. You
can use the no feature segmentation command to remove all the VXLAN bridge domain configurations
on the Cisco Nexus 1000V.
VXLAN Troubleshooting Commands
Use the following commands to display VXLAN attributes.
This section contains the following topics:
•
•

VSM Commands

To display ports belonging to a specific segment:
switch(config)# show system internal seg_bd info segment 10000
Bridge-domain: A
Port Count: 11
Veth1
Veth2
Veth3
To display the vEthernet bridge domain configuration:
switch(config)# show system internal seg_bd info port vethernet 1
Bridge-domain: A
segment_id = 10000
Group IP: 225.1.1.1
To display the vEthernet bridge configuration with ifindex as an argument:
switch(config)# show system internal seg_bd info port ifindex 0x1c000050
Bridge-domain: A
segment_id = 10000
Group IP: 225.1.1.1
To display the total number of bridge domain ports:
switch(config)# show system internal seg_bd info port_count
Number of ports: 11
To display the bridge domain internal configuration:
switch(config)# show system internal seg_bd info bd vxlan-home
Bridge-domain vxlan-home (2 ports in all)
Segment ID: 5555 (Manual/Active)
Group IP: 235.5.5.5
State: UP
is_bd_created: Yes
current state: SEG_BD_FSM_ST_READY
pending_delete: 0
port_count: 2
action: 4
Cisco Nexus 1000V Troubleshooting Guide, Release 4.2(1)SV2(2.1)
23-4
VSM Commands, page 23-4
VXLAN Gateway Commands, page 23-5
Mac learning: Enabled
Chapter 23 VXLANs
OL-28795-01