Pioneer PRV-LX10 Operating Instructions Manual page 39

Note 3:
Be careful when using a keyboard to insert chapter
marks, since if the Enter key is held depressed,
multiple consecutive chapter marks may be inserted.
2 Automatic Recording
RS-422A or IEEE1394 interface protocols can be
used to control an external VTR and perform
automated recording.
7 Recording Using IN/OUT Points Setting
On the Function Menu's APP section, use the
[Auto Capture] = [IN/OUT Point] = [IN/OUT
Point] command to set the time code for the IN and
OUT points. When the Function Menu's REC button
is then pressed, the external VTR is automatically
rewound to a position just preceding the selected IN
point, and recording starts automatically from that
point. When the designated OUT point is detected,
the unit automatically enters the REC pause/stop
mode.
APP section = [Auto Capture] = [IN/OUT Point]
= [IN/OUT Point]
The preroll time preceding the IN point can be
changed from between 1 to 10 seconds before the
point by using the Function Menu's APP section =
[Auto Capture] = [IN/OUT Point] = [Preroll Time]
command. The time code delay compensation
(offset) can be set to from 0 to –30 frames by using
the APP section = [Auto Capture] = [IN/OUT
Point] = [Offset (Frame)] command.
Note:
Frame accuracy during use of the auto recording
function is as follows:
SET UP section = [Operation]
= [Control Settings]
= [Time Code]
RS-422A
LTC
IEEE1394
In order to match the phase with the input time
code, the preroll should be set to about five seconds.
The preroll value must be corrected using the source
side component.
APP section = [Auto Capture] = [IN/OUT Point] =
The APP section = [Auto Capture] = [IN/OUT
Point] = [Record As] command allows designation of
whether recording enters the REC pause mode, or
stops completely when the OUT point is detected.
When "Chapter (Pause)" is selected, the command
also permits the insertion of a chapter mark at that
point. When manual chapter mark insertion has been
previously selected, optional chapter marks can be
inserted by pressing the ENTER button during
recording.
Offset (Frame)
value
± 1 Frame
± 1 Frame
± 1 Frame
APP section = [Auto Capture] = [IN/OUT Point]
= [Preroll Time]
[Offset (Frame)]
APP section = [Auto Capture] = [IN/OUT Point]
= [Record As]
Recording
39
PRV-LX10
En