Pioneer DVR-650H-S Operating Instructions Manual page 114

The Initial Setup menu
14
Setting
Remote Control
Mode
DivX VOD
Set Preview
(HDD only)
Options 2
USB
HDD Sleep Mode
Additional information about the TV system settings
About the input line system
This recorder is compatible with PAL-N, 3.58
NTSC and PAL-M TV systems. The Input Line
System and Input Colour System settings
determine how the recorder treats incoming
video signals from an external input or the
114
built-in TV tuner.
En
Options Explanation
Recorder 1–3 If you are using more than one recorder in the same
(default: Recorder 1) room, set them to different IDs. This setting sets the
recorder ID; to change the remote controller ID, press
and hold RETURN then press 1, 2 or 3 to set. The
remote will only control a recorder with the same ID.
Registration Code Use to display the recorder's DivX registration code.
See DivX video compatibility on page 10 and DivX®
VOD content on page 11.
Quick Preview • When in the Disc Navigator, the thumbnail video
plays short excerpts from throughout the selected
title. (Note that edited titles that will play normally
from the beginning.)
Normal The thumbnail video plays from the beginning of the
title.
Restart USB
If the connected USB device does not respond to the
Device recorder, try using this option to restart it. If the
device still does not work properly try switching it off
then back on, and/or disconnecting then
reconnecting the USB cable.
Confirm Printer Use this option to confirm the make and model of the
printer connected to the recorder (does not work with
all printers).
Proceed
Puts the HDD to sleep. Using this feature when
playing DVDs or CDs allows you to reduce noise
produced by the unit, resulting in improved sound
quality. When you wake the HDD back up it will take
a few seconds to load.
The HDD can be taken out of Sleep Mode by any
number of actions, including:
• Turning the power off and on again.
• Pressing the HDD/DVD button and choosing the
HDD.
• When a timer recording begins.
• When you try and make any changes to system
settings.
Please note the following points when
changing the input line system:
• If, when the Input Line System setting is
changed, the screen goes blank (due to
incompatibility with your TV), you can
switch back by pressing and holding the
front panel (Stop) button then