Automatic Transmission Assembly - Subaru IMPREZA 2002 Service Manual

1
AUTOMATIC TRANSMISSION ASSEMBLY
I
AUTOMATIC TRANSMISSION
9) Install the torque converter clutch to drive plate.
(1) Tighten the bolts which hold torque convert-
er clutch to drive plate.
(2) Tighten the other bolts while rotating the en-
gine by using ST.
CAUTION:
Be careful not to drop bolts into the torque con-
verter cl utc h housing
.
Turbo model
ST 499977300 CRANK PULLEY WRENCH
Non-turbo model
ST 499977100 CRANK PULLEY WRENCH
Tightening torque:
25 N.m (2.5 kgf-m, 18.1 ft-lb)
(3) Clog the service hole with a plug.
10) Remove the ST.
11) Install the pitching stopper.
Tightening torque:
T1: 50 N.m (5.1 kgf-m, 37 ft-lb)
T2: 58 N.m (5.9 kgf-m, 43 ft-lb)
12) Lift-up the vehicle.
Install the front drive shafts into transmission.
(1) Lift-up the vehicle.
(2) Install the front drive shaft into transmission.
(3) Drive the spring pin into chamfered hole of
drive shaft.
CAUTION:
Always use a new spring pin.
13) Install the ball joint into housing.
14) Connect the stabilizer link to transverse link,
and temporarily tighten the bolts.
CAUTION:
Discard the loosened self-locking nut and re-
place with a new one.
Tightening torque:
T1: 30 N.m (3.1 kgf-m, 22.4 ft-lb)
T2: 50 N-m (5.1 kgf-m, 37 ft-lb)
15) Install the shift select cable onto select lever.
<Ref. to CS-27, INSTALLATION, Select Cable.>
16) Install the ATF level gauge guide, and connect
the ATF cooler hoses to pipe.
AT-23