Subaru IMPREZA 2002 Service Manual page 89

I
ATF COOLER PIPE AND HOSE
AUTOMATIC TRANSMISSION
B: INSTALLATION
1. NON-TURBO MODEL
1) Install the oil cooler outlet and inlet pipes.
CAUTION:
Be sure to use a new aluminum washer.
Tightening torque:
T1: 44 N-m (4.5 kgf-m, 32.5 ff-lb)
T2: 25 N-m (2.5 kgf-m, 18.1 ff-lb)
(A) Inlet pipe
(B) Outlet pipe
2) Install the ATF cooler pipe to cylinder head.
Tightening torque:
7.35 N-m (0.75 kgf-m, 5.42 ft-lb)
3) Connect the ATF cooler hose to pipe transmis-
sion side.
NOTE:
Install so that the hose is not folded over, exces-
sively bent, or twisted.
Be careful to insert the hose to the specified po-
sition.
4) Connect the ATF cooler hose to pipe of radiator
side.
NOTE:
Install so that the hose is not folded over, exces-
sively bent, or twisted.
Be careful to insert the hose to the specified po-
sition.
5)
S2M0895
istall the under cover.
6) Fill ATF. <Ref. to AT-9, Automatic Transmission
Fluid.>
NOTE:
Make sure there are
no
ATF leaks in joints between
the transmission, radiator, pipes, and hoses.
AT-49