Subaru IMPREZA 2002 Service Manual page 82

SHIFT SOLENOIDS, DUTY SOLENOIDS AND ATF TEMPERATURE SENSOR
e
AUTOMATIC TRANSMISSION
I
1. TRANSFER DUTY SOLENOID AND
TRANSFER VALVE BODY
1) Install the transfer duty solenoid and transfer
valve body.
(1) Install the transfer duty solenoid and trans-
fer valve body.
Tightening torque:
T: 8 N-m (0.8 kgf-m, 5.8 ft-lb)
(2) Connect the transfer duty solenoid connec-
tor.
c .
(A) Transfer valve body
(B) Transfer duty solenoid connector
(C) Transfer duty solenoid
2) Install the extension case to transmission case.
Tightening torque:
(1) Tighten eleven bolts.
25 N-m (2.5 kgf-m, 18.1 ft-lb)
(2)
Adjust the select cable. <Ref. to CS-27, AD-
JUSTMENT, Select Cable.>
3) Install the rear vehicle speed sensor.
Tightening torque:
T: 7 N.m (0.7 kgf-m, 5.
t
ft-lb)
4) Install the rear crossmember.
Tightening torque:
(1) Tighten the bolts.
T I : 35 N-m (3.6 kgf-m, 26 ft-lb)
T2: 70 N.m (7.1 kgf-m, 51.4 ft-lb)
(2) Lower and remove the transmission jack.
5) Install the propeller shaft. <Ref. to DS-15, IN-
STALLATION, Propeller Shaft.>
6) Install the front exhaust pipe and center exhaust
pipe.
7) Lower and remove the jack.
8) Connect the transmission harness connector.
9) Install the pitching stopper.
Tightening torque:
T1: 50 N.m (5.1 kgf-m, 37 ft-lb)
T2: 58 N.m (5.9 kgf-m, 43 ft-lb)
IO) Install the air cleaner case and duct.
AT-42