Install Or Replace The Battery Pack - Fluke BT520 User Manual

Install or Replace the Battery Pack

Never operate the Product with the Battery Cover removed.
Hazardous voltage exposure may occur.
To install or replace a Battery Pack:
1. Make sure the Product is off.
2. Remove all probes and/or test leads.
3. Unlock the battery cover at the rear of the Product. Turn the screw a half turn.
4. Install the battery pack.
5. Put the battery cover back on the unit.
6. Tighten the screw.
Figure 7-1 shows how to install or replace a battery pack.
1
Warning
Figure 7-1. Install or Replace a Battery Pack
Maintenance
Install or Replace the Battery Pack
2
7
hsz005.eps
7-3