Removing The Primary System Memory (Ram) - Clevo P870KM Service Manual

Disassembly

Removing the Primary System Memory (RAM)

Figure 6
RAM Module
The computer has four memory sockets for 260 pin Small Outline Dual In-line (SO-DIMM) DDR 4 type memory modules.
Removal
The total memory size is automatically detected by the POST routine once you turn on your computer.
a. Locate the module.
Note that four SO-DIMMs are only supported by Quad-Core CPUs; Dual-Core CPUs support two SO-DIMMs maxi-
b. Gently pull the two
release latches on mum.
the sides of the
Two primary memory sockets are located under component bay cover (the bottom case cover), and two secondary
memory socket(s) in
the direction indicat-
memory sockets are located under the keyboard (not user upgradable). If you are installing only two RAM modules
ed below.
then they should be installed in the primary memory sockets under the component bay cover.
c. The RAM module
will pop-up, and you
Note that the RAM located under the keyboard is not user upgradable.
can remove it.
Memory Upgrade Process
1. Turn off the computer, and turn it over, remove the battery
2. The modules will be visible at point
3. Gently pull the two release latches (
(Figure 6b
4. The RAM module
a.

4. RAM Module
2 - 10 Removing the Primary System Memory (RAM)
(Figure 6a
1
) on the sides of the memory socket(s) in the direction indicated below
2 & 3
)
.
will pop-up, and you can remove it
4
1
(page 2 - 5).
) .
(Figure 6c ) .
b.
3
2
c.
5
4