Removing The Primary System Memory (Ram) - Clevo P775TM Service Manual

Disassembly

Removing the Primary System Memory (RAM)

Figure 6
RAM Module
The computer has four memory sockets for 260 pin Small Outline Dual In-line (SO-DIMM) DDR 4 type memory modules.
Removal
The total memory size is automatically detected by the POST routine once you turn on your computer.
a. Remove the screws.
Slide the bottom
Two primary memory sockets are located under component bay cover (the bottom case cover), and two secondary
cover until the cover
memory sockets are located under the keyboard (not user upgradable). If you are installing only two RAM modules
and case indicators
then they should be installed in the primary memory sockets under the component bay cover.
are aligned.
Note that the RAM located under the keyboard is not user upgradable.
Memory Upgrade Process
1. Turn off the computer, and turn it over, remove the battery
2. Remove screws
3. Slide the bottom cover until the cover and case indicators
a.
1
• 5 Screws
2 - 10 Removing the Primary System Memory (RAM)
- .
1 5
2
3
5
(page 2 - 5).
)
are aligned (Figure 6a .
6
4
6
6