Removing The Primary System Memory (Ram) - Clevo P177SM Service Manual

Disassembly

Removing the Primary System Memory (RAM)

Figure 10
RAM Module
The computer has four memory sockets for 204 pin Small Outline Dual In-line (SO-DIMM) DDR III (DDR3) type memory
Removal
modules (see
a. Remove the screws.
on your computer.
b. Remove the screws
at the rear of the Note that four SO-DIMMs are only supported by Quad-Core CPUs; Dual-Core CPUs support two SO-DIMMs maxi-
computer
mum (see
c. Slide the bottom
Two primary memory sockets are located under component bay cover (the bottom case cover), and two secondary
cover until the cover
memory sockets are located under the keyboard (not user upgradable). If you are installing only two RAM modules
and case indicators
then they should be installed in the primary memory sockets under the component bay cover.
are aligned.
Note that the RAM located under the keyboard is not user upgradable. Contact your service center for more information if you
wish to upgrade the memory in the secondary memory sockets.
Memory Upgrade Process
1. Turn off the computer, and turn it over, remove the battery
2. Remove screws
3. Remove screws
4. Slide the bottom cover in the direction of the arrow
10c
a.

• 6 Screws
2 - 14 Removing the Primary System Memory (RAM)
"Memory" on page 1 - 2 ). The total memory size is automatically detected by the POST routine once you turn
"Memory" on page 1 - 2 for full details).
- at the bottom of the computer
1 4
- at the rear of the computer
5 6
)
.
2
1
3
(page 2 - 5).
)
(Figure 10a .
(Figure 10b ) .
until the cover & case indicators
7
b.
5
4
c.
8
are aligned (Figure
8
6
7