Alcatel-Lucent OmniSwitch 6350 Hardware User's Manual page 109

Managing OmniSwitch 6350 Stacks
If there are only two switches in the stack, the switch that was reloaded (the former secondary) resumes
the secondary role when it comes back up.
Primary - Slot 1
Secondary - Slot 2
-> reload secondary
Primary - Slot 1
Booting...
Primary - Slot 1
Secondary - Slot 2
Reloading the Secondary Management Module In a Stack of Two
OmniSwitch 6350 Hardware Users Guide
In this stack of two OmniSwitch 6350 switches, the slot
1
1 switch is the primary management module. The slot 2
switch is the secondary.
The user reloads the stack's secondary management
2
module by issuing the reload secondary command. Any
data flow on the secondary switch's Ethernet is inter-
rupted.
As the secondary switch reboots, the primary manage-
3
ment module continues to operate without interruption.
Meanwhile the stack has no interim secondary manage-
ment module as the switch reboots.
When the rebooted switch comes back up, it assumes the
4
secondary management role within the stack.
April 2017
Reloading Switches
page 7-29