Table of Contents
Advertisement
6
Position the expansion card so the electrical contacts, the
gold "fingers," are aligned with the receptacle in the
expansion slot and the back edge of the card fits into the
groove on the plastic guide, as shown in Figure 7.
FIGURE 7 Lowering the expansion card into the receptable
Plastic
guides
Press down on the top edge of the card until you feel and
7
hear the card "lock" into place. The card is "locked" when
the frame of the card is flush with the frame of the unit.
If the card tilts or wobbles when you press on either end,
the card is not properly installed. Take out the card and
reinsert it. Be careful that you do not bend the card.
Make sure that the expansion card is not touching any
other card. If it is, move the card to another slot.
Be sure the bracket that replaces the slot cover slides into
its position.
Expansion
card
Call Management System Installation Guide
Gold "fingers"
Receptacle
15
Advertisement
Table of Contents
