Omron NS12 Quick Start Manual page 40

OMRON
If you download the programming example (described above), the PT should
start the RUN mode and first screen should be displayed.
An error message is displayed when screen data does not exist. Transfer screen data
again from the NS-Designer (or from Memory Card).
When the PT is connected using communications conditions other than the set
conditions, a message "Connecting..." will be displayed at the bottom right of the
screen, and the PT will be in standby status until a normal connection is possible. To
change the communications settings, select the System Menu and change the
settings.
The system menu can be displayed by pressing two of the four corners of the touch
panel simultaneously. There are many settings in the PT's System Menu. Many of
those are the same as System Settings in the NS-Designer.
Please be careful when editing any of these settings, as it may have a negative effect
on the proper working of the terminal, please refer to the NS-Series Setup Manual
(V083-E1-xx), section 6 for details!
Page 40
NS Series Quick Start Manual