Kyocera pdQ2 User Manual page 53

pdq2_QuickStart.book Page 49 Friday, July 28, 2000 6:37 PM
Replacing the battery
If you have to replace the battery in your pdQ
considerations.
If the battery becomes low, an alert appears on the screen. Before you
replace the battery, perform a HotSync operation to back up your
data. This helps prevent accidental data loss.
2
If the pdQ does not turn on when you press the End/Power key on
the keypad, recharge the battery immediately.
Before replacing the battery, turn the phone off. Never remove the
battery while the telephone features are active. To verify that the
phone is turned off, open and then close the flip. The words "Phone
is off" appear on the screen. Then the screen becomes blank.
Only remove the battery to replace it with another battery. Don't
leave the battery out of the pdQ
becomes drained while you are traveling and you don't have a
second battery or a cradle to recharge it, it is better to leave the
drained battery in the pdQ
If the battery drains completely, the pdQ
However, the built-in backup battery stores your clock settings for
about two days and your data for about seven days. There is enough
residual energy in the battery to store the data, but not enough to
turn on the pdQ
If you leave a drained battery in the pdQ
time (more than seven days), you can lose all of the stored data. If this
happens, replace the battery and reset the pdQ
HotSync operation to restore data from your computer.
Phone care
2
2
. For example, if your battery
2
than to remove it.
2
.
2
DRAFT
, be aware of the following
2
no longer operates.
for an extended period of
2
. Then perform a
49