Table of Contents
Advertisement
Demo mode
Guide for operating the system when installed in a shop display panel:
If the RGS 08 is to be operated in demo mode while installed in a
presentation panel (e.g. in a shop display), a minimum calibration
must be carried out. Firstly, switch off the TravelPilot. Next press the
cursor down
key and switch on the TravelPilot. After the service
menu appears, close it by accessing the Navigation menu item.
To run the demo mode, proceed as follows:
1. Select Demo from the DSC menu. The demo menu will then appear.
If Normal is selected, the route will be travelled along only once and
will then stop. A new destination must then be entered and route
guidance must be restarted.
If Auto repeat is selected, the demo will run in a continuous loop, i.e.
it will continue to repeat the route from the starting point to the desti-
nation.
2. After selecting one of these menu items, the system will restart.
3. After the system has restarted, select Enter location from the DSC
menu and, as described in the chapter entitled "Example for entering
a destination", select a town, a street and the appropriate junction.
After entering the address, the distance to the junction must then be
entered.
It is recommended that the position be set to 50 metres ahead by
positioning the cursor in front of 50 m ahead and pressing ENT.
4. Next, select Set location and press the ENT key.
40
Advertisement
Table of Contents
