Grandstream Networks UCM6200 Series User Manual page 48

Preferred DNS Server
WAN (when "Method" is set to "Route")
IP Method
IP Address
Subnet Mask
Gateway IP
DNS Server 1
DNS Server 2
User Name
Password
Layer 2 QoS
802.1Q/VLAN Tag
Layer 2 QoS 802.1p
Priority Value
LAN (when Method is set to "Route")
IP Address
Subnet Mask
DHCP Server Enable
DNS Server 1
DNS Server 2
Allow IP Address
From
Allow IP Address To
Default IP Lease Time
LAN (when Method is set to "Switch")
IP Method
IP Address
Subnet Mask
Gateway IP
DNS Server 1
DNS Server 2
Firmware Version 1.0.0.1
Enter the preferred DNS server address. If Preferred DNS is used, UCM will try to
use it as Primary DNS server.
Select DHCP, Static IP, or PPPoE. The default setting is DHCP.
Enter the IP address for static IP settings. The default setting is 192.168.0.160.
Enter the subnet mask address for static IP settings. The default setting is
255.255.0.0.
Enter the gateway IP address for static IP settings. The default setting is 0.0.0.0.
Enter the DNS server 1 address for static IP settings. The default setting is
0.0.0.0.
Enter the DNS server 2 address for static IP settings.
Enter the user name to connect via PPPoE.
Enter the password to connect via PPPoE.
Assign the VLAN tag of the layer 2 QoS packets for WAN port. The default value
is 0.
Assign the priority value of the layer 2 QoS packets for WAN port. The default
value is 0.
Enter the IP address assigned to LAN port. The default setting is 192.168.2.1.
Enter the subnet mask. The default setting is 255.255.255.0.
Enable or disable DHCP server capability. The default setting is "Yes".
Enter DNS server address 1. The default setting is 8.8.8.8.
Enter DNS server address 2. The default setting is 208.67.222.222.
Enter the DHCP IP Pool starting address. The default setting is 192.168.2.100.
Enter the DHCP IP Pool ending address. The default setting is 192.168.2.254.
Enter the IP lease time (in seconds). The default setting is 43200.
Select DHCP, Static IP, or PPPoE. The default setting is DHCP.
Enter the IP address for static IP settings. The default setting is 192.168.0.160.
Enter the subnet mask address for static IP settings. The default setting is
255.255.0.0.
Enter the gateway IP address for static IP settings. The default setting is 0.0.0.0.
Enter the DNS server 1 address for static IP settings. The default setting is
0.0.0.0.
Enter the DNS server 2 address for static IP settings.
UCM6200 Series IP PBX User Manual Page 47 of 320