Grandstream Networks UCM6200 Series User Manual page 124

CC Max Monitors
Ring Simultaneously
Ring Simultaneously
External Number
Time Condition for Ring
Simultaneously
Other Settings
Ring Timeout
Auto Record
Skip Trunk Auth
Time Condition for Skip
Trunk Auth
Dial Trunk Password
Support Hot-Desking Mode
Firmware Version 1.0.0.1
for this channel. In other words, this number serves as the maximum
number of CC requests this channel is allowed to make. The minimum
value is 1.
Configure the maximum number of monitor structures which may be
created for this device. In other words, this number tells how many callers
may request CC services for a specific device at one time. The minimum
value is 1.
Enable this option to have an external number ring simultaneously along
with the extension. If a register trunk is used for outbound, the register
number will be used to be displayed for the external number as caller ID
number.
Set the external number to be rang simultaneously. '-' is the connection
character which will be ignored.
Ring the external number simultaneously along with the extension on the
basis of this time condition.
Configure the number of seconds to ring the user before the call is
forwarded to voicemail (voicemail is enabled) or hang up (voicemail is
disabled). If not specified, the default ring timeout is 60 seconds on the
UCM6200, which can be configured in the global ring timeout setting
under web GUI->Internal Options->IVR Prompt: General Preference. The
valid range is between 5 seconds and 600 seconds.
Note:
If the end point also has a ring timeout configured, the actual ring timeout
used is the shortest time set by either device.
Enable automatic recording for the calls using this extension. The default
setting is disabled. The recording files can be accessed under web
GUI->CDR->Recording Files.

If set to "yes", users can skip entering the password when making
outbound calls.

If set to "By Time", users can skip entering the password when
making outbound calls during the selected time condition.

If set to "No", users will be asked to enter the password when making
outbound calls.
If 'Skip Trunk Auth' is set to 'By Time', select a time condition during which
users can skip entering password when making outbound calls.
Configure personal password when making outbound calls via trunk.
If enabled, SIP Password will accept only alphabet characters and digits.
UCM6200 Series IP PBX User Manual Page 123 of 320