Installing The Cd-Etia Blade In The Chassis - NEC SMB8000 Manual

Issue 3.0
___________________________________________________________________________________
1.3
S 2 SV8100
ECTION
SV8100 System:
The CD-ETIA blade can be programmed using a Multiline Terminal, PCPro or
WebPro.
1.
2.
___________________________________________________________________________________
3 - 2

Installing the CD-ETIA Blade in the Chassis

To install this blade with the system running:
1. Insert the blade within the guide rail and push the blade securely into
position. Tighten the thumb screws on either side of the blade.
Figure 3-1 Inserting Blades in the 19" CHS2U-US Chassis
SV8300 S
AND
To program the system, the CD-ETIA blade should be installed in the desired
universal slot.
Access System Programming press: Speaker
Transfer.
User
Password
Name
12345678 tech
P
YSTEM ROGRAMMING
Level
2 (IN) Installation (IN):
All programs in this section not listed below for
SA and SB
[system password]
# Q # Q
Programs at this Level
CD-ETIA Blade Setup
SMB8000