Operation - Superior Fireplaces VRT4032ZMN Installation And Operation Instructions Manual

FOR YOUR SAFETY
READ BEFORE LIGHTING
WARNING: If you do not fol-
low these instructions exactly,
a fi re or explosion may result
causing property damage, per-
sonal injury or loss of life.
A. This appliance has a pilot which must
be lighted by hand. When lighting the
pilot, follow these instructions exactly.
B. BEFORE LIGHTING smell all around
the appliance area for gas. Be sure to
smell next to the fl oor because some
gas is heavier than air and will settle
on the fl oor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electric switch; do
not use any phone in your building.
• Immediately call your gas supplier
from a neighbor's phone. Follow the
gas supplier's instructions.
• If you cannot reach your gas supplier,
call the fi re department.
C. Use only your hand to push in or turn
the gas control knob. Never use tools.
If the knob will not push in or turn by
hand, don't try to repair it, call a quali-
fi ed service technician or gas supplier.
Force or attempted repair may result in
a fi re or explosion.
D. Do not use this appliance if any part
has been under water. Immediately call
a qualifi ed service technician to inspect
the appliance and to replace any part of
the control system and any gas control
which has been under water.
22

OPERATION

WARNING: You must operate
this fi replace with the fi replace
screen in place. Make sure fi re-
place screen is installed before
running fi replace.
NOTICE: During initial operation
of new fi replace, burning logs
will give off a paper-burning
smell. Open damper or window
to vent smell. This will only last
a few hours.
1. STOP! Read the safety information in
column 1.
2. Make sure equipment shutoff valve is fully
open.
3. Set selector switch in OFF position.
come on automatically within
one minute when the selector
switch is in the ON position after
the pilot is lit.
4. Press in and turn control knob clockwise
5. Wait fi ve (5) minutes to clear out any gas.
Then smell for gas, including near the
fl oor. If you smell gas, STOP! Follow "B"
in the safety information, column 1. If you
don't smell gas, go to the next step.
6. Press in and turn control knob counter-
clockwise
Press in control knob for fi ve (5) seconds
(see Figure 39, Page 23).
NOTE: You may be running this heater
for the fi rst time after hooking up to gas
supply. If so, the control knob may need
to be pressed in for 30 seconds or more.
This will allow air to bleed from the gas
system.
CAUTION: Do not try to ad-
just heating levels by using the
equipment shutoff valve.
SuperiorFireplaces.us.com
LIGHTING
INSTRUCTIONS
WARNING: Burners will
to the OFF position.
to the PILOT position.
126868-01B