Superior Fireplaces VRT4032ZMN Installation And Operation Instructions Manual page 12

10. Carefully insert fi replace into cabinet mantel.
Be careful not to scratch or damage hearth
base, cabinet mantel, or any laminate trim
on hearth base. Remove protective material
from top of hearth base and from front of
fi replace (if any).
NOTE: You can secure fi replace to hearth
or fl oor. Remove burner assembly. Locate
screw holes in bottom of base. Tighten
wood screws through these holes and into
hearth or fl oor. Replace burner assembly.
11. Check all gas connections for leaks. See
Checking Gas Connections, Page 16.
Figure 10 - Installing Cabinet Mantel
Figure 11 - Location of Nailing Flange
12
INSTALLATION
Continued
Figure 12 - Inserting Fireplace Into
BUILT-IN FIREPLACE
INSTALLATION
Cabinet
Mantel
Built-in installation of this fi replace involves
installing fi replace into a framed-in enclosure.
This makes the front of fi replace fl ush with wall.
If installing a mantel above the fi replace, you
must follow the clearances shown in Figure
16, Page 13. Follow the instructions below to
install the fi replace in this manner.
Rough Opening Dimensions for Built-in
Model
32"
36"
1. Frame in rough opening. Use dimensions
shown in Figure 13 for the rough opening.
If installing in a corner, use dimensions
shown in Figure 14, Figure 12, for the
rough opening.
Nailing
Flange
Figure 13 - Rough Opening for Installing
SuperiorFireplaces.us.com
Cabinet Mantel
Installation
Front Width
Height Depth
(Inside to Inside)
34 7 / " 36
8
41 1 / " 40
2
Depth
(Minimum)
Height
Width
(Inside to Inside)
in Wall
3 / " 16 1 / "
4 4
1 / " 20 3 / "
2 4
126868-01B